Honda PCF ECU Hardware Reference
Technical reference for the Honda PCF ECU, including OEM part numbers and board identification.
The PCF ECU is a factory engine control unit utilized in specific Honda applications. Use the following specifications for identification and diagnostic purposes.
Hardware Specifications
| Attribute | Specification |
|---|---|
| OEM Part Number | 37820-PCF-N51 |
| PCB Reference | CY-EH2955A |
Note
Ensure the PCB reference number matches the physical unit before attempting any hardware modifications or diagnostic procedures.
Diagnostic Resources
Use the following tools to assist with ECU diagnostics and troubleshooting:
Resistor Color Code Reference
Use the color bands on through-hole resistors to identify their resistance value before installing ECU jumpers, pull-ups, voltage dividers, or sensor-scaling parts.
How to Read the Bands
| Resistor Type | Band 1 | Band 2 | Band 3 | Band 4 | Band 5 |
|---|---|---|---|---|---|
| 4-band | 1st digit | 2nd digit | Multiplier | Tolerance | - |
| 5-band | 1st digit | 2nd digit | 3rd digit | Multiplier | Tolerance |
Color Values
| Color | Digit | Multiplier | Tolerance |
|---|---|---|---|
| Black | 0 | x1 | - |
| Brown | 1 | x10 | +/- 1% |
| Red | 2 | x100 | +/- 2% |
| Orange | 3 | x1,000 | - |
| Yellow | 4 | x10,000 | - |
| Green | 5 | x100,000 | +/- 0.5% |
| Blue | 6 | x1,000,000 | +/- 0.25% |
| Violet | 7 | x10,000,000 | +/- 0.1% |
| Gray | 8 | x100,000,000 | +/- 0.05% |
| White | 9 | x1,000,000,000 | - |
| Gold | - | x0.1 | +/- 5% |
| Silver | - | x0.01 | +/- 10% |
| No band | - | - | +/- 20% |
Common ECU Examples
| Value | 4-Band Code | Typical Use |
|---|---|---|
| 220 ohm | Red, Red, Brown, Gold | LED/current-limiting or ECU hardware mods |
| 1k ohm | Brown, Black, Red, Gold | Pull-up, jumper, and driver-bias circuits |
| 1.2k ohm | Brown, Red, Red, Gold | Driver-bias circuits such as IACV repair references |
| 4.7k ohm | Yellow, Violet, Red, Gold | Transistor base resistor circuits |
| 10k ohm | Brown, Black, Orange, Gold | Pull-up, pull-down, and sensor-divider circuits |
Tip
Always confirm the measured value with a multimeter before soldering. Old ECU resistors can be heat-discolored, and some boards use small surface-mount parts marked with numeric codes instead of color bands.