General Hardware Assistance
Need help with ECU hardware?
-
negative TPS value?
title only -
Hondata cable replacement.
title only -
what programer is good??
title only -
Bleh...Datalogging - TX, RX question
title only -
What Happen to www.pgmfi.org
title only -
p71 obd1 or obd2??? and DLC question...
title only -
freelog or PLX R300 data
title only -
datalogging problems
title only -
best widdeband for viewing and tuning
title only -
ECU connector (EUDM)
title only -
Voltage Setting for Innovate RPM Converter
title only -
Logging Wideband thru O2
title only -
PO7 (1560 board) chipped?
title only -
Hardware gurus read please!! transistor woes
title only -
chipping a P08 jdm ecu
title only -
ECU auto to manual conversion
title only -
Bizzare power cut.....the "bog mode"
title only -
Blown capacitors on P28s
title only -
Check Engine Light - P28
title only -
p06 to p28 test - How to?
title only -
code 26 ?????
title only -
P30 AT to MT conversion help
title only -
Need help, obviously, p06 ecu
title only -
Chipping an ODB1 PR3
title only -
obd0 m74hc373p similar to the sn74hc373n
title only -
Wideband help
title only -
Wideband help
title only -
p30 931?
title only -
Help me understand address lines.
title only -
Need some help with the startup..
title only -
Help, Crome problem
title only -
can you run a chipped auto ecu with crome?
title only -
code 21 with P06 ecu chipped
title only -
The pocket programmer + crome
title only -
Jdm P30 Question
title only -
E-85?
title only -
whats the best chip programmer
title only -
idea for doing ecu's under 5 mins
title only -
Chip programmer
title only -
MAP formula
title only -
Strange CEL Problems
title only -
Zeitronix and CROMEPRO
title only -
Pulling my hair out! BURN1/Hulog related
title only