Peak And Hold Injectors
Peak And Hold Injectors aka Low Impedance Injectors. Impedance typically ~25ohms. At 12volts, this is a draw of ~62.
Adapted from pgmfi.org wiki
Peak And Hold Injectors aka Low Impedance Injectors. Impedance typically ~2-5ohms. At 12volts, this is a draw of ~6-2.4 amps The high current will cause the injectors to run hotter. The peak current opens the injector "crisply" and decisively. Then a lower "Hold" current keeps the injector open. To run these injectors with the honda ECU, you may need to use an inline Resistor Box. OBD0 already has a resistor box wired in. OBD1 does not have a Resistor Box. OBD2 does not have a Resistor Box.
Credits and source
Authors Anonymous PGMFI contributor
Source Adapted from Peak And Hold Injectors on pgmfi.org wiki. Licensed under CC BY-NC-SA 1.0.