02D01720-1500

Library.02D01720-1500 · r1.5 · 14 Mar 2007 · defensio

To convert a "1720" board from non-vtec to vtec add the following parts:

Required:

Q26: C2785 (*note: I used a C144 and it worked fine - NPN switching transistor)
C60: 1uF 35v tantalum (marked "1 ... 35" and blue w/+ mark)
IC14: 515 X High Side Switch
J10: jumper wire
R67: 820 Ohm, 1/8w 5% resistor (1k work fine says Deluded)
RM11: weird voltage divider (this is KEY but can be replaced. Click link for more info)this could be replace by a 10k 8pin resistor module work really well
D11: Clamping Diode

Optional:

C75,C89,C72,C74,C88: 22pF ceramic (marked "22")
IC13: 515 X High Side Switch (note)
R66: 820 Ohm, 1/8w 5% resistor (1k work fine says Deluded)

This is Honda's first OBD1 Civic/Integra vtec design. It is more complicated than it needs to be - the optional components are overkill.

#IC13note : IC13 is entirely superfluous. You can 100% safely remove it and install J10 to bypass it. IC13+IC14 are run in series, so if you have both installed you actually increase the probability of failure becuase you have 5x5x to possibly fail, not one.

Find the Parts For ECUs Here

C60 and J10 - Top left of the case:

Resistor setup in RM11:

Q26 NPN Transistor:

IC14 5151S (thanks to Xenocron) AND R67 Resistor:

D11 Diode - upper left in the case:

overview with comment:

Attachment:	Modify:	Size:	Date:	Who:	Comment:
DSCF1764.JPG	mod	466150	14 Mar 2007 - 01:41	defensio	C60 and J10 - Top left of the case
DSCF1766.JPG	mod	467869	14 Mar 2007 - 01:43	defensio	Resistor setup in RM11
DSCF1765.JPG	mod	480298	14 Mar 2007 - 01:44	defensio	Q26 NPN Transistor
DSCF1762.JPG	mod	475259	14 Mar 2007 - 01:45	defensio	D11 Diode - upper left in the case
DSCF1759_modified.JPG	mod	1179213	14 Mar 2007 - 02:28	defensio	overview with comment
DSCF1763.JPG	mod	468390	14 Mar 2007 - 05:10	defensio	IC14 5151S (thanks to Xenocron) AND R67 Resistor

Attachments